Exergy for A Better Environment and Improved Sustainability 2

Ibrahim Dincer is a Professor at the Department of Automotive, Mechanical and Manufacturing Engineering Faculty of Engineering and Applied Science, at the University of Ontario Institute of Technology. He's an Editor-in-Chief of three academic journals and a board member for many more. He is the author and editor of numerous Springer titles. Aloui Fethi is a Professor at the University of Valenciennes with interests in fluid mechanics, energetics, inverse methods among others.

Part 1: Environment impact assesment and potential solutions.- Chapter1. Wastes of Oil Drilling: Treatment Techniques and Their Effectiveness.- Chapter2. Comparative study of the adsorption of Nickel on a natural bentonite and on a Streptomyces rimosus dead biomass.- Chapter3. Process Simulation and Energy Consumption Analysis for CO2 Capture with Different Solvents.- Chapter4. Experimental Investigation of n-Butanol/Diesel Fuel Blends and n-Butanol Fumigation -Evaluation of Engine Performance, Exhaust Emissions and Heat Release.- Chapter5. Effects of temperature and biodiesel fraction on densities of commercially available diesel fuel and its blends with the highest methyl ester yield corn oil biodiesel produced by using NaOH.- Chapter6. Effects Of Temperature And Biodiesel Fraction On Dynamic Viscosities Of Commercially Available Diesel Fuels And Its Blends With The Highest Methyl Ester Yield Corn-Oil Biodisel Produced By Using Of KOH.- Chapter7. Sankey and Grassmann diagrams formineral trade in the EU-28.- Chapter8. Development of Solid Waste Management System for Adana Metropolitan Municipality.- Chapter9. Regeneration of Peel of Peas (Pisum Sativum) after Zinc Adsorption.- Chapter10. Diesel engine performance and emission study using soybean biodiesel blends with fossil diesel.- Chapter11. The Valorization of the Green Alga Spirogyras Biomass in the Region of Ouargla-Algeria Into Renewable Biofuel.- Chapter12. Plasma Technologies for Water Electrolyzers.- Chapter13. Determination of Metals in Water and Sediment Samples of the Srmene River, Turkey.- Chapter14. The effect of Surfactant on Selectivity in Extraction of Aromatic Hydrocarbons From Lube Oil.- Chapter15. Biodiesel Production by Transesterification of Recycled Vegetable Oils.- Chapter16. Membrane Desalination Technology in Algeria: Reverse Osmosis for Coastal Areas.- Chapter17. A study on energy and environmental management techniques used in petroleum process industries.- Chapter18.- Generating Temperature Maps of a Solar Receiver for a Domestic Parabolic Concentrator for Cooking Purposes Under Algerian Environment.- Chapter19. Experimental Investigations on the Effects of Low Compression Ratio in a Direct Injection Diesel Engine.- Chapter20. Control of Cement Slurry Formulation for Oil Well in Critical Geological Layer.- Chapter21. Recovery of Waste Farm after Methanization by Evaporation on Inclined Plate.- Chapter 22. Optimal Operation of MEA-Based Post-Combustion Carbon Capture Process for Natural Gas Combined Cycle Power Plants.- Chapter23. Experimental and Numerical Investigations of Fabrication of TiO2 Compact Layer by the Spray Pyrolysis Deposition System for Dye-Sensitized Solar Cells.- Chapter24. Experimental Investigation on Citrullus Colocynthis Oil as Alternative Fuel.- Chapter25. A Novel Approach to Local Level Design of Bioenergy Supply Chains Integrated with District Heating Systems.- Chapter26. Kinetic Study of Plastic Wastes With and Without Catalysts.- Chapter27.- Effect of Ballast Water on Marine Ecosystem.- Chapter28. Regeneration of Waste Frying Oil for Biodiesel Production.- Chapter29. The Effect of Air with Supplementary Oxygen on Power and Fuel Consumption of Spark-Ignition Engine.- Chapter30. A comparative Study on Some Methods to Use Tyre Pyrolysis Oil as an Alternative Fuel in a DI Diesel Engine.- Chapter31. Investigation of Effects of Natural Gas Composition on One-Dimensional Comprehensive Engine Model Calibration.- Chapter32. Experimental Results of Split-flow Modification for Post-Combustion CO2 Capture Process.- Chapter33. Hydrogen Production from Methanol Electrolysis.- Chapter34. Experimental investigation of polypropylen pyrolysis for fuel production.- Chapter35. Experimental Analysis of Hydrogen Fuelled Homogeneous Charge Compression Ignition (HCCI) Engine.- Part 2: Sustainable buildings.- Chapter36. Experimental Analysis of Thermal Comfort of building Integrated Phase Change Materials.- Chapter37. Determining Opt