Control, Mechatronics and Automation Technology

Dawei Zheng International Research Association of Information and Computer Science, China

• Preface; A Multistage Conjugate Multiplied Accumulation algorithm for frame synchronization of DVB-S2 system; Research on time synchronization on the basis of TWSTFT; H robust tracking control for the image stabilizing system of optical telescope; Experimental study on pressure-balanced brush seals at low speeds; Research about BP learning process of Fuzzy Neural Network Control of Ultrasonic Motor base on different learning rates; The design of the control system in the urban traffic Platform Screen Door; A new method of dynamic detection for vehicle load based on Empirical Mode Decomposition; Research on AMDB modeling and display techniques; A comparative study of nonlinear filters in Pilot-Induced Oscillation caused by actuator rate limiting; Design and development of simulation system based on virtual DCS; PSO-based Tuned Mass Damper control for high-rise structure excited by simulated fluctuating wind field; Extended State-Observer-based Sliding Mode Control for unmatched uncertainty; Develop semi-physical simulation platform of turbine DEH control system based on IAP; Vehicle detection using local symmetry filter; Longitudinal velocity tracking control for EV based on MPC; H-infinity control strategy research for engine idle start/stop control; Research on FOG signal process based on wavelet transform; Effects of contact frequency on cascade models; A security mechanism based on Electronic Product Code technology for logistics security; Non-uniform signal reconstruction based on time base error in time-interleaved ADC system; Research on fault knowledge excavating technique based on design information of products; Research on the construction of traffic meteorological service system in Chongqing; A method of testing the static parameters of A/D converter; TVOS content security analysis and protection in smart TV; Research on applied innovative talent training mode of automobile service engineering based on the concept of CDIO; Conceptual design of aY-configuration VTOL UAV; Design and implementation of a cross-platform and cross-method SNMP extension MIB system; Information spreading in module networks with stifling effect; Collective synchronization on module networks with tunable clustering coefficients; Modeling and simulation of super-low-altitude satellite attitude motion in free molecular flow; YAG laser cutting plate surface quality of the research were reviewed; Research of dynamic queue scheduling algorithm; Evidence fusion improved algorithm based on similarity measure; Volumetric efficiency of the diesel engine optimized design based on multiple factors; Design for the pitching hydraulic system of reclaimer; Influence factor analysis for stiffening girder bridge line of concrete self-anchored suspension bridge; The display architecture design of Xuanquan site…/Part Contents