Jashanpreet Singh is currently working as Assistant Professor in University Centre of Research and Development & Department of Mechanical Engineering at Chandigarh University, Mohali. He had obtained his PhD degree in the field of Slurry Erosion and Thermal Spray Coatings from Thapar Institute of Engineering and Technology, Patiala in 2019. He has done his B. Tech. and M. Tech. in Mechanical Engineering at Punjabi University, Patiala in 2012 and 2014 respectively. He has a teaching experience of more than six years and industry experience of more than two years. His area of research is Tribology-Solid particle erosion, Thermal spray coatings, CFD simulation, Composites, and Materials characterization. He has authored/edited 05 books under CRC Press & Taylor and Francis banner. He has authored over hundred research publications in various International Journals, Books and Conferences of repute. He is a life member of AICTSD, IAENG, and NITTSD. Satish Kumar is presently working as a Professor in the Department of Mechanical Engineering at National Institute of Technology Jamshedpur. Currently he is holding the post of Dean (Research and Consultancy), Faculty In-charge Admission, Controller of Examination, Chairman of Institute Publication Cell, Chairman of Institute News-letter at NIT Jamshedpur. He has obtained his Bachelor’s and Master degree in Mechanical Engineering from SVNIT Surat in 2002 and 2004 respectively. He has completed his Ph.D. under the supervision of Professor B. K. Gandhi, Department of Mechanical and Industrial Engineering, IIT Roorkee in the area of solid – liquid flow in 2014. His research interests are rheology of slurry flow, computational fluid dynamics, erosion wear, air jet erosion, high temperature oxidation, and flow phenomena of solid-liquid flow in pump and pipeline. He authored (and co-authored) over 150 research articles in the field of multiphase flows and coatings. He supervised 08 PhD and 55 M. Tech. Thesis in the area of Multiphase flow. He has completed 05 sponsored research project funded by different agencies like SERB, DST, UGC successfully. Currently, a total of 03 research projects are on-going. He is a life member of ISTE, ASME, NSFMFP, IAENG, Institution of Engineers, NITTSD, etc. Mirosław Szala is presently working as an Assistant Professor in the Department of Materials Engineering at Lublin University of Technology, Lublin. His research interests are cavitation and slurry erosion, abrasion, tribology, failure analysis, additive manufacturing, thermal spraying, thin films, shot peening, ion implantation, hardfacing, welding, Co/Ni alloys, metal matrix composites, stainless and structural steels, fatigue, and materials characterization. He authored (and co-authored) over ninety research articles in different journals and conference proceedings. He has edited for journals like Advances in Science and Technology Research Journal, Materials, Crystals, Metals and Processes. He is a reputed reviewer of many SCI and SCOPUS indexed journals. He is the conference convener of one of the most reputed conferences in Poland namely Computational Methods in Engineering Science (CMES).
