3D Printing

A Practical Guide for Librarians

AvSara Russell Gonzalez,Denise Beaubien Bennett

Häftad, Engelska, 2016

Del 22 i serien Practical Guides for Librarians

966 kr

Beställningsvara. Skickas inom 10-15 vardagar. Fri frakt över 249 kr.

Fler format och utgåvor

E-bok

1 124 kr

Beskrivning

Planning and implementing a 3D printing service in a library may seem like a daunting task. Based upon the authors’ experience as early adopters of 3D technology and running a successful 3D printing service at a large academic library, this guide provides the steps to follow when launching a service in any type of library. Detailed guidance and over 50 graphics provide readers with sage guidance and detailed instructions on:planning a proposalprinter selection tipspreparing the locationaddressing staff concerns for new servicedeveloping service workflows and proceduresmanaging inevitable disastersdeveloping policiesconducting the “reference interview” for 3D printingstaff training tipsoutreach activitiesThis book brings into one place all the guidance you need for developing and implementing a 3D printing service in any library.

Produktinformation

Utgivningsdatum:2016-05-08
Mått:213 x 280 x 12 mm
Vikt:535 g
Format:Häftad
Språk:Engelska
Serie:Practical Guides for Librarians
Antal sidor:190
Förlag:Bloomsbury Publishing Plc
ISBN:9781442255487

Utforska kategorier

Referensverk och tvärvetenskap inom Samhälle och politik

Mer om författaren

Sara Russell Gonzalez is the Physical Sciences, Mathematics, and Visualization Librarian at the Marston Science Library at the University of Florida. A former geophysicist, her research interests include emerging technologies in libraries, modeling and visualization of data, and scientific literacy instruction. She coordinates the Marston Science Library Visualization room, the MADE@UF software development lab, and the 3D printing service with Denise Bennett.Denise Beaubien Bennett is an Engineering Librarian Emeritus at the Marston Science Library at the University of Florida. She held many offices in divisions of ALA, including RUSA and RUSA MARS, the ACRL Science and Technology Section, and MARBI. She served as General Editor for ALA's Guide to Reference, and as the Division Editor of its Science, Technology, and Medicine Section. Her research interests include database searching, indexing, and evaluation; science librarianship; evaluation of reference tools; and responsible conduct of research (RCR) training. Her latest service interest is implementing 3D printing in academic libraries.

Recensioner i media

Our library has been offering 3D printing to our campus community since the summer of 2014, and boy would this book have been handy when we were getting started! It strikes a balance between offering enough information to get started, but not being overwhelmingly technical. I especially appreciated the inclusion of legal considerations specific to 3D printing.

Innehållsförteckning

List of IllustrationsPrefaceAcknowledgmentsChapter 1. 3D Printing and its Applications in LibrariesChapter 2. 3D Printing and PrintersChapter 3. Before You Can Print: Getting a Model Chapter 4. What Makes a Good Printable Model?Chapter 5. Estimating Expenses and Assessing Your ServiceChapter 6. Developing Your 3D Printing Services Chapter 7. Policy DevelopmentChapter 8. Workflow Chapter 9. Preparation and Staff TrainingChapter 10. Dealing with DifficultiesChapter 11. Outreach and MarketingChapter 12. Looking AheadGlossary IndexAbout the Authors